Freshtel SPA-2000 User Manual download pdf

Sipura SPA-2000

Manual Configuration Instructions

Only settings that deviate from factory defaults are included in this document. If your ATA

was previously connected to a different service, you will need to use the screenshots to verify

that all settings are correct; alternatively, you may reset the ATA to factory defaults

(recommended), as described in section 4.

1. Plug in the ATA

Connect a telephone handset, network, and power to the ATA, and wait briefly while it

discovers its IP address via DHCP. For more information on connecting your ATA, or to set a

Static IP Address manually, please consult your User Manual.

2. Determine the ATA’s IP Address

To find out the ATA's IP Address, dial "****", then "110#". Note down the IP Address spoken

out and enter it into the address bar of a Web browser.

Example: If the address is "10.34.238.6", enter this as "http://10.24.238.6/".

If the address read out is "0.0.0.0", the ATA was unsuccessful in acquiring an IP address via

DHCP -- contact your network administrator before proceeding.

3. Reset the ATA to Factory Defaults (optional).

Note: This will clear all custom settings from the ATA; if you wish to retain these for later

reference, please make a note of them (for example, by printing the configuration pages, or

saving a copy of them to disk).

To perform the reset, dial "****" on the attached telephone handset, followed by "73738#",

then "1" to confirm; then hang up. Once the phone is hung up, the ATA will restart with its

settings reset to factory defaults.

1 2 3 4 5 6 7 8

Sipura SPA-2000 Manual Configuration Instructions Only settings that deviate from factory defaults are included in this document. If your ATA

Page 2

4. Configure the ATA via its web interface Bring up the ATA's Web configuration page, as described in section 2 of this document. Click on

Page 3

SIP NAT Support Parameters Handle VIA received: yes Handle VIA rport: yes Insert VIA received: yes Insert VIA r

Page 4

Distinctive Ring Patterns Ring 1 Cadence: 60(1.5/3.4) Ring 3 Cadence: 60(1.5/3.4,.4/.2,.4/2,.4/.2,.4/2,.4/.2,.4/2,.4/.2,.4/2,.4/.2,.4/

Page 5

Regional (all countries) Miscellaneous Time Zone: GMT+10:00 <or as appropriate> FXS Port Impedance: 600 &

Page 6

Line 1 (and 2, if using a different Firefly number on the second line) NAT Mapping Enable: yes NAT Keep Alive Enable: yes N

Page 7

Audio Configuration Preferred Codec: G729a NOTE: It is vital that the dial plans are entered correctly – as there is not enough space

Dial Plan (UK only -- user has local dialing prefix set) (*123|*xxxxxxxx|999 S0|112 S0|18000 S0|18001999 S0|0800112999 S0|[2-9]xxxxxxx|[2-9]xxxx

No comments

Freshtel SPA-2000 User Manual